Forum pracy nad projektem wskrzeszenia The Forge

[fasfsdas]

then there will be letters to describe a layer or a rotating surface, and direction: for example: R (on behalf of the right 90 degrees clockwise), R `(on behalf of the right turn 90 degrees counterclockwise), R2 (2 times on behalf of the right turn 90 degrees clockwise)
following is shown:

2. Then the white corners homing (Cheats said, very complex and easier to understand,[link widoczny dla zalogowanych], or plug-Rights)

*** Sina

*** tips and share with you:
First of all, *** cube, we must first understand its structure, 6-color 6-sided cube, each side is divided into the central block (the middle of the block 6), corners (4 corner block and the side blocks (four at the edge of the block 12). Of which only one side the central block, they are a fixed structure, so central is the red block,[link widoczny dla zalogowanych], then the red should be the other side to this focus. And red is always the center of the block opposite the central block of orange (international standard is so specified). The block has two side faces two colors,[link widoczny dla zalogowanych], corners there are three faces three colors.
final note is: the name of each side is relative, for example, F is the front of the cube is the time for his own hand side, if we imitate the rotation to the other side,'The 10 couples sleeping position .., then there is a new side of a front.

Well, let's try the next
the following 7 steps to restore the cube it!

1. first side of the middle of the block is white (with a piece of rubiks logo) facing the top, and then make a white cross at the top, that is, all other colors of the blocks to the appropriate position (small complex, see picture, note the subject of the above formulas Oh, did correct )

6. Usually this time yellow block, and the dislocation will have the color of the side, according to formulas (I have not fully digested) to locate the four corners of the yellow block.

7. Finally, the edge of the color and then adjust to the corresponding location. You're done!! Thrill.
3. Then let the middle edge pieces into place.
the white face turned to the next, find the red and green side of the block, if the red and green on the top side of the block according top clockwise until the edge of the block in Figure 1 on the same situation, in accordance with the formulas rotating cube, so that side of the block into place. If the red and green side of the block in the middle of a layer, but in the wrong place or color error, the first block on the right side of the red and green position in front, and then re-spin in accordance with one of the following sequence 1.


4. Then the top (should be yellow) side of the block to adjust upward, making yellow cross. If the rotation in accordance with formulas 1, the top not a yellow cross, repeatable formulas by turning, until the yellow cross appears.


Next we will use the letters on behalf of each sides,


5. Then adjusted to cross the yellow around corners, a bit difficult to see formulas clue.